Comes with the following features and Specs

• 1 - RM3 TRANSISTOR
• FREQUENCY: 25 - 30 MHz
• AM/FM
• INPUT POWER: 1-5 W AM/FM
• OUTPUT POWER: 25 - 35 WATT AM/FM - Lower the input the higher the output, I have seen up to 50 - 60 watts out of this board
• 5A FUSE
• 3 1/2"(L) X 1 7/8"(W) X 1/2"(T) or thick

This amp can work on SSB/CW if you install a switch to switch between the two - on SSB/CW it will handle 2 -10 Watt of input power and produce 50 - 70 Watts of output

YOU DO NOT HAVE TO REMOVE YOUR SPEAKER FOR THIS AMP BOARD - INSTALLS INSIDE THE RADIO WITHOUT REMOVING ANYTHING

About the same size as an ECHO BOARD

This is the same board that is installed inside the KL-60 LINEAR except for a few changes made so you can install this into your radio

VERY EASY TO FOLLOW INSTRUCTIONS FOR INSTALLATION

THIS AMP WILL MAKE YOUR RADIO TALK THE WAY YOU HAVE DREAMED OF IT BEING ABLE TO DO

If you can solder and read directions you can install this amp in your radio. If any concerns or doubts, take it to a Radio Shop and have it done.